| Webbing and Hardware Meets SFI Spec 16.1 |
| 3" Shoulder Harness - Bolt in Mount Meets USAC, NASCAR, SCCA regulations. Modified, Sprint, Indy, Formula and Stock Cars. Each fastens individually, bolt in. Snap end available. Can be used in any latch type belt. Standard length 32" from mounting bracket to 3" adjuster. Overall length from mounting bracket to buckle is 44". |
| 3" Shoulder Harness - Roll Bar Mount For use with 3" lap belt unit. Will work with other units of 3" type. Snap End can be added to roll bar harness using 30309 mounting hardware. Can be mounted anywhere there is a structural tube running horizontally behind driver and below shoulders. Can be used in any latch type belt. Comes with mounting tabs on harness. |
| 3" Shoulder Harness - Wrap Around Ends - Floor Mount Designed to mount by looping around a roll bar structural tube running horizontally behind the driver and below shoulders. This is individually mounted. Designed to work with any latch type belt. |
| Snap End - Floor Mount Kit Works with any lap belt or shoulder harness kit. (1 side only) |
| Bolt End - Floor Mount Kit |
| NOTE: All prices subject to change |
| Disclaimer. Please read: This product is sold without warranty expressed or implied. No warranty or representation is made as to the product's ability to protect the user from any injury or death in any manner of use. The user assumes that risk. The effectiveness of this equipment are directly related to the manner in which it is installed, used, and/or maintained. Proper installation is solely the responsibility of the installer, and will not be assumed by Fastrack Safety. |
| Fastrack Safety |
| 3" Shoulder Harnesses |
 |
 |
 |
 |
 |
 |